AW FIREGUARD

SECTION 3: PHYSICAL DATA

BOILING POINT: Not Applicable.
VAPOR PRESSURE: Not Applicable.
VAPOR DENSITY: Not Applicable.
SOLUBILITY IN WATER: < 1%.
SPECIFIC GRAVITY: Not Available.
PERCENT VOLATILE BY VOLUME: 2.8 g/L
EVAPORATION RATE: Not Applicable.
pH: (1% solution) Not Applicable.
APPEARANCE & COLOR: This material is a clear paste with no discernible color.

SECTION 4: FIRE AND EXPLOSION DATA

FLASH POINT: (260 degrees C.
FLAMMABLE LIMITS: Not Applicable.
EXTINGUISHING MEDIA: Water spray, Carbon Dioxide, Foam, Dry Chemical, Halon, any other "B" Class extinguishing agent.
SPECIAL FIREFIGHTING PROCEDURES: Incipient fire responders should wear eye protection. Structural fire fighters must wear Self-Contained Breathing Apparatus and full protective equipment.

SECTION 5: HEALTH HAZARD DATA

THRESHOLD LIMIT VALUE: Silica amorphous treated 10 mg/m3.
OSHA PEL: Silica amorphous treated 6 mg/m3.
EFFECTS OF OVEREXPOSURE: This product may cause mild skin irritation, moderate eye irritation and possible gastric distress. This product is not known to cause chronic illness.

EMERGENCY FIRST-AID PROCEDURES:
SKIN EXPOSURE: If spilled on skin IMMEDIATELY begin decontamination with running
water.
Remove exposed or contaminated clothing, taking care not to contaminate eyes. If reddening or
irritation occurs, victim and rescuers must seek immediate medical attention.
EYE EXPOSURE: If chemical gets into the eyes, open victim's eyes while under gentle running
water.
Use sufficient force to open eyelids. Have victim "roll" eyes. MINIMUM flushing is for 15 minutes.
INHALATION: If spray or mist is inhaled, remove victim to fresh air. If necessary, use artificial
respiration to support vital functions. If irritation of the nose or throat occurs, the victim and
rescuers must seek immediate medical attention.

SECTION 6: REACTIVITY DATA

STABILITY DATE: Stable.
INCOMPATIBILITY: Strong acids, strong bases, strong oxidizers.
HAZARDOUS DECOMPOSITION PRODUCTS: Carbon monoxide, carbon dioxide, silicon dioxide.
HAZARDOUS POLYMERIZATION: Will not occur.

SECTION 7: SPILL OR LEAK PROCEDURES

SMALL SPILLS: Wipe up spilled liquid with absorbent material. Place residue in a double plastic bag & seal.
LARGE SPILLS: Use Level C: triple gloves, chemically resistant suit and boots, hard hat, and air purifying respirator with an acid gas/organic vapor cartridge..
FOLLOW STATE AND LOCAL REGULATIONS FOR DISPOSAL OF LARGE NON-RECLAIMABLE SPILLS.

SECTION 8: SPECIAL PROTECTION INFORMATION

RESPIRATORY PROTECTION: Not expected to be needed. Maintain oxygen levels of minimum of 19.5% If below 19.5% oxygen, use supplied air respiratory protection.
VENTILATION: Use with adequate ventilation. Use fan or vent to outside.
PROTECTIVE GLOVES: Wear rubber gloves for routine industrial use.
EYE PROTECTION: Safety glasses.
OTHER PROTECTIVE EQUIPMENT: None except for large spills (see Section 7)

HMIS: 0-0-0 NFPA: 0-0-0

SECTION 9: SPECIAL PRECAUTIONS

PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE: Follow reasonable and safe practices.
Avoid getting chemicals ON YOU or IN YOU.

OTHER PRECAUTIONS: Store this product below 43(C.

ANSI Z400.1-1993 FORMAT MSDS AVAILABLE ON REQUEST

MATERIAL SAFETY DATA SHEET		PAGE 1 OF 2
U.S. DEPARTMENT OF LABOR		REVIEWED: MARCH 1, 2001
		Abbrev.

COMPLIES WITH USDL SAFETY AND HEALTH REGULATIONS (29 CFR 1910.1200)



SECTION 1:	MANUFACTURER:	PRODUCT IDENTIFICATION

	Amerex Corporation P.O. Box 81 Trussville, AL 35173-0081	V-728 Lubricant Silicone Lubricant

	EMERGENCY: Chemtrec:1-800-424-9300 Amerex: 1-205-655-3271

		%	*ACGIH mg/m3			*OSHA mg/m3		OTHER mg/m3
CHEMICAL NAME	CAS #	W/W	TLV	STEL	PEL	STEL	IDLH

Dimethyl Polysiloxane	63148-62-9	89-94	NE	NE	NE	NE	NE	NE
Silica amorphous treated	112945-52-5	4-7	10	NE	6**	NE	NE	DFG MAK 4

NE = None Established *NOTE: OSHA exposure information: 20 mppcf (million particles per cubic foot) or (80 mg/m3/%SiO2).

MATERIAL SAFETY DATA SHEET		PAGE 2 OF 2
MANUFACTURER: AMEREX CORPORATION		DATE: 08-15-96
PRODUCT IDENTIFICATION: V-728 Lubricant		Abbrev.